There will be signs at the on-ramp or along the road to tell you the minimum number of people. You have a certain number of people in your vehicle.To use an HOV lane, one of these must apply: Carpool/High-Occupancy Vehicle (HOV) LanesĪn HOV lane is a special lane reserved for carpools, buses, motorcycles, or low-emission vehicles with decals. On a multilane road, the passing lane (far left lane) is the lane closest to the center divider and is used to pass other vehicles. If you miss a turn, keep driving until you can safely and legally turn around. If you start to make a turn, follow through. Once you start moving through an intersection, keep going. Last minute lane or direction changes may increase the risk of collisions. It is not necessary to slow down before a lane change. Be sure there is enough space for your vehicle in the next lane.Do not let the vehicle drift into another lane. Check your blind spots for other vehicles, motorcyclists, and bicyclists.Look over your shoulder in the direction you plan to move to make sure the lane is clear.Use the right lane to enter or exit traffic.Use the left lane to pass or turn left.Broken White Linesīroken white lines separate traffic lanes on roads with two or more lanes in the same direction. Wait until you see a single broken white line. Never change lanes over double solid white lines. You may also see double solid white lines in or near freeway on and off ramps. Double Solid White Linesĭouble solid white lines indicate a lane barrier between a regular use and a preferential use lane, such as a carpool (HOV) lane. Single Solid White LineĪ single solid white line marks traffic lanes going in the same direction. Broken Yellow LineĪ broken yellow line indicates you may pass if the broken line is next to your driving lane. Do not drive on or over this barrier, make a left turn, or make a U-turn across it, except at designated openings. Two sets of solid double yellow lines spaced two or more feet apart are considered a barrier. Turning left across a single set of double yellow lines to enter or exit a driveway or private road or make a U-turn.Instructed by construction or other signs to drive on the other side of the road because your side is closed or blocked.In a high-occupancy vehicle (HOV) carpool lane that has a designated entrance on the left.Stay to the right of these lines unless you are: Double Solid Yellow Linesĭo not pass over double solid yellow lines. Do not pass a vehicle in front of you if there is only one lane of traffic going your direction and a solid yellow line on your side of the road. Single Solid Yellow LineĪ single solid yellow line marks the center of a road with two-way traffic. Lane markings on road surfaces help drivers know which part of the road to use and understand traffic rules. P.S.A traffic lane is a section of road for a single line of traffic. Will you be reserving the Fireworks Punch and make these scrapbook borders? Step 4: Using the Fireworks Punch, punch three shapes with White Solid Cardstock and two with Crimson Solid Cardstock. Adhere the “Magical moments” sticker using Foam Squares for added dimension. Step 3: Adhere a castle sticker on the middle of the border as shown. When reassembling your cut rays onto the borders, place every other one onto the second cardstock strip. Simply cut a second 4” x 12” strip of Black Solid Cardstock. *You may wish to create a second border for the opposite side of a two-page layout since you’re only using half of your “rays”. Cut off 1/2″ from each side, leaving a 3” x 12” piece. Using the 12-inch Trimmer, cut apart on the lines, reassembling them on the Black Solid Cardstock strip. Continue drawing “rays” from near the middle of one side radiating up and down on the other side, using the photos below as a guide. Using a ruler and pencil, draw a line from the 6” mark on one long side to the 6-1/4” mark on the other side. Place lightning bolts strip on the 13×13 Custom Cutting System Mat. Cut a 4” x 12” strip with lightning bolts paper. Step 2: Cut a 4” x 12” strip with Black Solid Cardstock*. Cut a 3-1/4” x 12” strip with White Solid Cardstock and adhere on the base. Step 1: Cut a 3-5/8” x 12” strip with maroon stripes paper for the base.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |